Countertop Installation in Arlington Heights, IL

Yes — all of Arlington Heights, and the rest of Cook County with it. The shop is 5.9 miles away at 2260 Elmhurst Rd in Elk Grove Village, and the crew that templates your kitchen is the crew that installs it. No part of Arlington Heights is far enough away to be somebody else's problem.

Yes - crooked houses are normal cabinet installation, not a special condition. Installers set base cabinets to the highest point of the floor and shim everything else up to level, scribe filler strips against wavy walls, and hide gaps with matching molding; frameless cabinets tolerate less error than framed, so precision matters more if you go European style. Expect a careful site measure with a level and laser before ordering - an installer who measures obsessively up front is protecting you from counters that roll cans and doors that swing open on their own. If a floor is badly out of level over a short run, flag it early; fixing the floor first is occasionally cheaper than fighting it with shims.

Bigger than it looks: the sink perimeter is the universal countertop killer in homeowner issue data, and dark, soft, or lifting caulk means water is already getting through. On laminate and butcher block, moisture swells the substrate permanently; on stone, it works at the seam adhesive and the cabinet below — in replacement timelines, recaulking bought about a year once swelling had started, and untreated sink-edge leaks progressed to rotted sink-cabinet floors within 2-3 years. Strip and recaulk at the first darkening (a $15 DIY job with silicone rated for kitchens), and treat a soft or spongy substrate as a replacement conversation, not a caulk conversation.

Completely normal. Cooktop cutouts, faucet holes, and small edge adjustments are routinely done on site because the final fit is verified against your actual walls and appliances. What separates a careful crew from a sloppy one is containment: wet cutting keeps silica dust down but produces a milky slurry that can stain concrete driveways, and any indoor dry-cutting should be minimal, shrouded, and vacuumed. Reasonable questions to ask: where will you cut, what goes down to protect the surface, and who cleans up the slurry. In a Midwest winter, expect the garage to become the workshop for a few hours.